Rinnai Amplify Installationsanleitung PDF herunterladen (Seite 6)

6 | Rinnai Heating Specication Guide 02-13

Location considerations

The following general guidelines should be factored when deciding on where to position

a Rinnai heating solution.

Clearances

All Rinnai appliances are subject

to clearances. Examples for the

Energysaver 559FT and Portable

Convectors are shown on this

page. For additional clearance

details, refer to the speciﬁc

product pages in this guide.

Fixed ventilation

Rinnai Portable Convectors

and Indoor Super Ray heaters

(unﬂued appliances) draw

the air for combustion from

the room, so there is a need

for adequate ventilation. This

ventilation must be provided as

per the Gas Regulationsthe

gasﬁtter installing the heater is

responsible for this.

Suitability

It is important to review the

suitability statements for each

heating solution, for example;

Indoor Super Rays are only

suitable for commercial and

industrial use and Portable

Convectors are subject to

minimum room sizes. Portable

Convectors also cannot

be installed in a bedroom,

bathroom, toilet, sauna, spa

room, or hallway. For further

information, refer to each of the

product speciﬁcation pages in

this guide.

Electrical connection

All Rinnai heating

solutions require

electricity to

operate (except

the Indoor Super Ray manual

models). Consideration must

be made as to where the power

point can be positioned.

A 3-pin plug with a 1500 mm

power cord is supplied with all

Rinnai appliances. This must be

plugged into a dedicated

230 V 10 A earthed power

point. Power boards and double

adaptors must not be used.

Flooring

Heat emanating from the front

of Rinnai Energysavers and

Portable Convectors may over

time aﬀect the appearance of

some materials used for ﬂooring

such as carpet, vinyl, cork or

timber. This eﬀect may be

ampliﬁed if the air in the room

contains cooking vapours or

cigarette smoke. To avoid this

occurring a mat or rug may

need to be positioned in front

of the applianceextending

about one metre in front of it.

Super Ray positioning

Super Ray heaters direct their

heat via infra-red rays, which

discharge the heat energy upon

striking a surface. They do not

pass through solid materials.

From a heating and safety point

of view obstructions to the path

of the rays must be taken into

consideration.

250 mm

1000 mm

50 m

m 50 mm

TOP

FRONT

LEFT SIDE

RIGHT SIDE

50mm

750mm

50mm

50mm

50mm

Energysaver 559FT clearances

Portable Convector clearances

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare